9. You can now pump the unit with your foot to inject material into the valve.
10. Before removing the coupler from the valve or when the hydraulic pump is not in
use, release the pressure on the hydraulic pump by depressing the foot pedal in "release"
WARNING! If the pump is activated when the sealant barrel cap (1407) is
removed, the piston assembly (2008) can be pumped out of the cylinder.
* Dispose of any expelled material properly.
Injecting Material Into Your Valve
1. The gun is equipped to couple onto a giant buttonhead fitting.
2. Monitor the gauge during pumping to avoid excessive pressure.
3. It takes approximately
11 strokes
to inject 1 ounce of material.
Periodic Maintenance For Pump
Refer to the Enerpac instruction sheet EIS 63.107-1 (9/2004) included in this manual for
maintenance requirements on the pump.
