Installation
6
CD-MP3 Emulation Mode Selection (CD-MP3 emulation)
CD-MP3 Emulation Mode programming steps:
@
Properly install MML player.
@
Put the “Left” programming switch in the “DOWN” position.
@
Put ignition switch into the “ACC” position.
@
Wait for a long beep followed by a few short beeps. This may take up to one minute.
@
Return programming switches to their default position (both switches “UP”).
Wait up to 30 seconds until confirmation beep.
@
Put ignition switch into the “OFF” position.
@
Wait at least 10 seconds.
@
Put ignition switch into “ACC” or “ON” position.
@
Check SoundLinQ for functionality, especially TEXT capabilities.
Mounting unit using Velcro fasteners
!
Velcro Fasteners are not included
!
VAIS Technology strongly recommends grounding the unit to the car chassis for best results.
NOTE
Carpet or car chassis
“Soft” Velcro Fastener
“Hard” Velcro Fastener
MML (MultiMediaLinQ)
WARNING
!
We strongly recommend to Ground MML to the vehicle’s chassis
i
!
1 2
ON
Left switch
“DOWN”
Ignition into
“ACC” or “ON”
position
Confirmation beep
(Yellow LED blinks)
Both switches
“UP”
ON
1 2
up to 30 sec
Confirmation beep
(Yellow LED blinks)
Ignition into
“OFF” position
up to 10 sec
Yellow LED
