4 Operation
8
Operating instructions ecoTEC plus 0020220342_01
You can find an overview of the menu structure in the ap-
pendix.
Operator level
–
overview (
→
Page 12)
4.4
Operating levels
The product has two operating levels.
The operating level for the operator shows the information
and offers set-up options that do not require any special prior
knowledge.
The operating level for the competent person is protected by
a code.
4.5
Cabinet-type casing
Enclosing the product in cabinet-type casing requires compli-
ance with the applicable design instructions.
If you require cabinet-type casing for your product, consult
a heating specialist company. Never, under any circum-
stances, enclose the product yourself.
4.6
Opening the isolator devices
1.
Ask the competent person who installed the product to
explain to you where these isolator devices are located
and how to handle them.
2.
Open the gas isolator cock fully.
3.
Open the service valves in the heating installation's flow
and return.
Conditions
: Product with integrated hot water generation or connected
domestic hot water cylinder
▶
Open the cold water stop valve.
4.7
Starting up the product
▶
Only start up the product once the casing has been com-
pletely closed.
4.8
Switching on the product
50
1
2
▶
Press the on/off button
(1)
.
◁
The "Basic display" (
→
Page 7)
(2)
appears on the
display.
4.9
Setting the heating flow temperature
1.
Press
( ).
◁
The target value of the heating flow temperature
appears on the display.
Note
The competent person may have adjusted
the maximum possible temperature.
Conditions
: No controller connected
▶
Use
or
to set the required heating flow temperat-
ure.
▶
Confirm by pressing
.
Conditions
: Controller connected
▶
Set the maximum possible heating flow temperature on
the product.
▶
Confirm by pressing
.
▶
Set the required heating flow temperature on the control-
ler (
→
Controller operating instructions).
4.10
Setting the hot water temperature
1.
Press
(
).
◁
The set hot water temperature flashes in the display.
Conditions
: No controller connected
▶
Change the hot water temperature by pressing
or
.
▶
Confirm by pressing
.
Conditions
: Controller connected
▶
Use
to set the maximum possible hot water temper-
ature on the product.
▶
Confirm by pressing
.
▶
Set the required hot water temperature on the controller
(
→
Controller operating instructions).
4.11
Switching Comfort mode on and off
Note
Comfort mode immediately supplies hot water at
the required temperature, without you having to
wait for the water to heat up.
1.
Press
(
).
2.
Press
(
).
◁
Comfort on
or
Comfort off
are shown flashing in
the display.
3.
Activate or deactivate Comfort mode by pressing
or
respectively.
4.
Press
to confirm this change.
◁
When you have activated Comfort mode, the " "
symbol appears on the basic display. When you
have deactivated Comfort mode, the " " symbol
goes out on the basic display.
