Pan/Tilt PRO
Pan/Tilt PRO - Document 341-590 Rev. A
Page 7 of 10
•
Step C: Non-Canon Camcorders:
The cross point of the two centers of gravity should go through the center point of the tilt hub of the
assembly, as is shown Figure 9.
•
Step D: Non-Canon Camcorders:
Loosen the thumb screw to remove the EZ Camera Shoe and camcorder from the bracket assembly.
Using the four (4) 6-32 ½” Allen screws, lock tooth and flat washers supplied, place the arm/bracket
assembly up against the tilt hub. Place two screws holes of the pan hub that match the center of gravity
with the center point of the pan/tilt hub. Place the remaining screws in two other holes of the tilt hub and
tighten all four screws. Reattach the camcorder and EZ Camera PRO Shoe assembly to the bracket.
Lifting the Pan/Tilt PRO assembly by the camcorder support bracket can damage internal
components and void the warranty. Pick the assembly up only from the main body of the
Pan/Tilt head.
Before starting the next step, disconnect power from the Pan/Tilt PRO.
Figure 9:
Match the center of gravity with the center point of the tilt hub of the Pan/Tilt PRO