Pan/Tilt PRO
Pan/Tilt PRO - Document 341-590 Rev. A
Page 5 of 10
•
Step C: Canon Camcorders:
After the Pan/Tilt PRO head is installed on the mount, set up the Camcorder Bracket assembly. Find the
Mounting Arm and Bracket, along with the two (2) 8-32 ½” screws, #8 lock tooth and #8 flat washers and
the 9/64” Allen wrench.
Place the arm on a flat surface, and set the bracket on the arm so that 4 holes are exposed. Put the lock
tooth and regular washers on each of the screws, and place them into the slots tightening them down
using the 9/64” Allen wrench (see Figure 4).
•
Step D: Canon Camcorders:
Using the four (4) 6-32 ½” Allen screws, lock tooth and flat washers supplied, place the arm/bracket
assembly up against the tilt hub. Place two screws in the top left and right holes of the tilt hub. Place the
remaining screws in the holes just below.
For the Canon camcorders, place the screws into the top two sets of screw holes on the tilt hub, at
approximately one inch (25 mm) for the upper set of screws and approximately ½” for the lower set of
screws from the bottom of the slots and tighten all screws, being careful not to strip out the Allen screw
heads (Figure 6).
Figure 5:
Mounting bracket mounted to arm
with 4-holes visible from the front of
the arm.
Figure 6:
Mounting position for the Canon
camcorders - note the Allen screws
are in the top two sets of holes of the
tilt hub.