OneLINK Device Configuration
After installation is complete and the OneLINK device and camera are operational, you will need to change
the AEC reference if you made the audio connections as shown in these diagrams.
On the Audio page of the OneLINK Bridge web interface, set Master Output/AEC Reference to Output 2 if
using Line Out 2 for the speaker connection.
Camera Configuration
Set HDMI resolution and IR forwarding using the switches on the back of the camera:
n
Set HDMI output resolution using the rotary switch.
n
Set DIP switch 3 DOWN to enable IR forwarding.
Codec Control Mode and other configuration settings are available from the camera's web interface. Point
the remote at the camera and press the Data Screen button to see the camera's IP address on the
connected HDMI display.
Enable Codec Control Mode on the DIP Switches tab of the System page.
Note
Codec Control Mode was added to Vaddio cameras in early 2018. Your camera may require a firmware
update to add this capability.
38
Installation Guide for the OneLINK Bridge AV Interface
