VADDIO AutoTrak 2.0, Installation And User Manual

Page: 49 / 52

AutoTrak 2.0 Camera Tracking System
AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. E Page 49 of 52
Appendix 1: HD-18 Connector Information

DE-15-F (HD-15F Connector)

EZCamera Power & HD Video RJ-45 Connector Pin-outs
( For HD-18 Camera and Quick-Connect SR and
Quick-Connect DVI/HDMI SR Interfaces - 568B Wiring Standard)

RS-232 and IR OUT RJ-45 Connector Pin-outs
( For HD-18 Camera and Quick-Connect SR and Quick-Connect
DVI/HDMI SR Interfaces - 568B Wiring Standard)
Communication Specification AutoPresenter or Serial CPU Interface
Communication Speed: 9600 bps

Start bit: 1

Stop bit: 1

Data bits: 8

Parity: None

No Flow control
Notes:

A total of six (6) presets can be accessed with a control
system via RS-232

Each Command must be followed by a line feed <lf>

Presets are set up on the Preset-Tracking Camera tabs under the AutoPresenter Camera Preset Area. No trigger assignments
are needed. Set the Tracking Camera position and store the preset. Recall the preset with the commands above.

The Preset OFF command must be issued to return to active tracking.

R99<lf> Will reset/reboot the AutoTrak CPU
Pin YPbPr
1 Pr
2 Y
3 Pb
4 -
5 -
6 Pr GND
7 Y GND
8 Pb GND
9 -
10 -
11 -
12 -
13 -
14 -
15 -
Pin YPbPr
1 Power+
2 Power-
3 Y+
4 PB+
5 PB GND
6 Y GND
7 PR+
8 PR-
Pin # RS-232 and IR OUT RJ-45
1 Unused
2 Unused
3 -
4 -
5 -
6 GND
7 RXD (from TXD of control source)
8 TXD (to RXD of control source)
RS-232 Command Description
P00<lf> Preset Off (back to active tracking)
P01<lf> Preset 1 for Tracking camera
P02<lf> Preset 2 for Tracking camera
P03<lf> Preset 3 for Tracking camera
P04<lf> Preset 4 for Tracking camera
P05<lf> Preset 5 for Tracking camera
P06<lf> Preset 6 for Tracking camera
R99<lf> CPU Reset Command
12345678
12345678