page 24 of 63
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. Manual-no.: 999188 / 19/05/2009
The controller CVC 3000 can be adapted to the specific application by choosing the appropriate function
depending on the connected components.
Automatic detection of the components
When switching on the controller the actual configuration of the connected components is checked
automatically.
Connected components
(valves, sensors, pumps) are
detected automatically
and used and super-
vised until the controller is switched off.
The last mode of operation and the preselected values (e. g. for pressure, speed or time for switching
off) are stored.
In case of similar operation conditions it is possible to start immediately, if the preselections are chosen
appropriately.
The controller has five functions and one menu for configuration, see section ”Menu guide”. The several
functions include specific preselection possibilities and are adapted automatically with regard to the
connected components.
Depending on the connected components (valves, pump,...) some menu might not be active!
Changing the function:
➨
Switch controller on.
➨
Press START/STOP if control is running.
➨
Press key MODE.
➨
Select function with knob and press to confirm.
☞
Depending on selected function the controller controls different components.
’’Pump down’’
• Pump and / or isolation valve depending on pressure and time preselections
• Coolant valve
”Vac control”
• Pump and / or isolation valve depending on pressure preselection in two-point control
• Coolant valve
’’Program’’
• Pump or isolation valve depending on pressure and time preselections
• Coolant valve
• Venting valve
”VACUULAN”
• Pump or isolation valve depending on pressure and time preselections
• Coolant valve
’’Configuration’’
Preselections for
• Adjustment of the pressure transducer
• Interface RS-232
• Sensors (configuration and switching between several sensors)
• Display (brightness and contrast of the display, language, sound)
• Autostart (automatic restart after power failure)
• Defaults (Resetting the controller is to factory set values)
☞
The menu ”Configuration” is also accessible by pressing the selection knob while the start display is
shown.
Notes on selecting the function
