C
ONTROL
PANEL
VACON
•
43
24-hour support (0)201 212 575 • Email: [email protected]
7
7.4.3 Monitoring menu
Figure 7.4: Monitoring menu display
Monitoring values are actual values of measured signals as well as status of some
control settings. It is visible in Vacon 10 display, but it can not be edited. The moni-
toring values are listed in Table 7.2.
Pressing Left/Right button to change the actual parameter to the first parameter of
the next group, to browse monitor menu from V1.x to V2.1 to V4.1. After entering the
desired group, the monitoring values can be browsed by pressing UP /DOWN button,
as shown in Figure 7.4.
In MON menu the selected signal and its value are alternating in the display by
pressing OK button.
NOTE!
Turn on drive power, arrowhead of main menu is at MON, V x.x or monitor pa-
rameter value of Vx.x is displayed in Panel.
NOTE!
Display Vx.x or monitor parameter value of Vx.x is determined by the last
show status before power shut down. E.g., it was V4.5, and it is also V4.5 when re-
start.
OK
OK
OK
1
2
3
Press Left/Right to browse
other Monitoring groups
Prsess Down to
browse V4.5
5
Press OK V4.5 is display
4
Preess OK the value is
displayed
FAULT
ALARM
S TO P
RE ADY
RU N
RE F
M ON
PAR
SYS
RE F
M ON
PAR
SYS
FAULT
ALA RM
S TO P
RE ADY
RU N
F WD
R EV
I/O
K EY PAD
BUS
F WD
R EV
I/O
K EY PAD
BUS
Press OK to enter
Monitoring menu
RE F
M ON
PAR
SYS
FAULT
ALA RM
S TO P
RE ADY
RU N
F WD
R EV
I/O
K EY PAD
BUS
RE F
M ON
PAR
SYS
FAULT
ALARM
S TO P
RE ADY
RU N
F WD
R EV
I/O
K EY PAD
BUS
FAULT
ALARM
S TO P
RE ADY
RU N
RE F
M ON
PAR
SYS
F WD
R EV
I/O
K EY PAD
BUS
