48
•
VACON
START-UP
Tel. +358 (0)201 2121 • Fax +358 (0)201 212 205
8
8. START-UP
8.1 Quick start-up wizard
Note!
You should only use the wizard when starting up the controller, since param-
eters are reset to their factory default values every time it is used. If you need to
change a particular value, you are recommended to go to the specific parameter (see
page 54).
Figure 8.1: Startup wizard
8.2 System identifcation function
In order to identify the pump, we must follow the steps listed below:
1. Completely close the pressure unit discharge to prevent water intake.
Pres-
sure must be 0 bars
.
FAU LT
ALARM
S TO P
READY
RUN
REF
MON
PAR
SYS
FAU LT
ALARM
S TO P
READY
RUN
REF
MON
PAR
SYS
FAU LT
ALARM
S TO P
READY
RUN
REF
MON
PAR
SYS
FWD
REV
I/O
KEY PAD
BUS
FWD
REV
I/O
KEY PAD
BUS
FWD
REV
I/O
KEY PAD
BUS
FWD
REV
I/O
KEY PAD
BUS
2
1
4
3
Change
P1.3
value
with Up/Down button
and press OK to
comfirm
Perform the same
procedure for
P1.4, motor nominal current;
P1.7, the type of autochange ;
P1.8, the number of auxiliary
pumps; P1.9, desired work
pressure in Kg
Press OK enter
edit mode
Enter Par. menu, select
P1.3 motor nominal speed
FAU LT
ALARM
S TO P
READY
RUN
REF
MON
PAR
SYS
OK
OK
rpm
