Vacmaster CDM0610P, Original Instructions Manual

Page: 9 / 20

9
GB
UNPACKING AND CHECKING CARTON
CONTENTS
ASSEMBLY
NOTE: A Phillips screwdriver is required.
1. Remove all the contents from inside of the vacuum cleaner container.
2. Your vacuum cleaner comes ready for dry vacuum cleaning with the pre-filter pre-installed. If
the pre-filter is not installed, refer to page 10.
3. Optionally, for improved dust filtration, remove the pre-installed pre-filter, and then fully fit the
dust bag flange onto the inlet stub (Fig. 1). Place the pre-filter back into the container. The
vacuum cleaner can be used with or without dust bags.
4. Secure the power head back on the container, using the 2 push-to-lock side latches. Insert the
locking end of the hose into the suction port of the container and turn clockwise to lock into
place (Fig. 2).
5. Choose the desired accessories and/or extension wands and push fit onto the hose nozzle
(Fig. 3).
6. Attach the detachable power cable to the connection lead using the cable restraint hook (Fig. 4).
1 Power Head 9 Accessory Storage 17 Round Dust Brush
2 Latch 10 Exhaust Filter Door 18 Pre-filter (pre-installed)
3 Rear Wheel 11 Hose Storage 19 Extension Wand (x2)
4 Front Caster 12 Power Cable Hook 20 Exhaust Filter (pre-installed)
5 Suction Port 13 Suction Hose 21 Detachable Power Cable
6 Container 14 Dual Mode Floor Nozzle 22 Cable Restraint Hook
7 On/Off Switch 15 Dust Bag (x5) 23 Instruction Manual
8 Carry Handle 16 Crevice Tool