Vacmaster CDM0610P, Original Instructions Manual

Page: 11 / 20

11
GB
MAINTENANCE
WARNING:
REMOVE THE POWER CORD FROM THE POWER SUPPLY BEFORE
CARRYING OUT ANY MAINTENANCE.
1) Keep all safety devices, air vents and the motor housing free of dirt and dust. Use a soft, dry
brush to clean the equipment regularly.
2) Clear all dirt or debris from the container after each use. Allow to dry before replacing the power
head. Do not use cleaning agents or solvents; these may damage the appliance.
3) Check the hose, attachments, and power cord to verify that they have not been damaged or
any debris is trapped and blocking airflow.
1. Cleaning the Pre-filter
1) Remove the pre-filter and clean by gently tapping or brushing dirt off. For optimal performance
it is recommended to replace the old filter with a new filter regularly.
2) If necessary, use a mild soap and water solution to wash pre-filter and rinse with clean water.
Allow the filters to air dry before re-installing.
2. Cleaning the Air Inlet Filer
1) Remove the air inlet filter by releasing the holding pin. Firmly press the two open ends of the
holding pin together and remove from the securing tabs (Fig. 7)
2) Remove the air inlet filter and use a mild soap and water solution to wash air inlet filter and
rinse with clean water. Allow the filter to air dry before re-installing.
3. Cleaning & Replacing Exhaust Filter
1) Unlock the exhaust filter door by lifting both of locking tabs upwards to release. Pull the door
out (Fig. 8).
2) Remove the exhaust filter from the vacuum cleaner and clean by gently tapping or brushing off
dirt. For optimal performance it is recommended to replace the old filter with a new filter
regularly (Fig. 9).
3) Install the cleaned or new filter. Then insert the filter door tabs into the upper slots and lock the
filter door into place.
4. Storage
1) Ensure the power cable hook is fully rotated into the storage position. Wrap the power cable
loosely around the power cable hook (Fig. 10).
2) To release the power cable, rotate the power cable hook towards the front of the vacuum
cleaner.
3) Store the suction hose around the hose storage (Fig. 11).