TZIDC, TZIDC-200
| COI/TZIDC/TZIDC-200-EN 5
1
Safety
Change from one to two columns
1.1
General information and instructions
These instructions are an impo rtant part of the product and
must be retained for future reference.
Installation, commissioning, and maintenance of the product
may only be performed by trained specialist personnel who
have been authorized by the plant operator accordingly. The
specialist personnel must have read and understood the
manual and must comply with its instructions.
For additional information or if speci
fi
c problems occur that are
not discussed in these instruct ions, contact the manufacturer.
The content of these instructions is neither part of nor an
amendment to any previous or ex isting agreement, promise or
legal relationship.
Modi
fi
cations and repairs to the product may only be
performed if expressly permitted by these instructions.
Information and symbols on the product must be observed.
These may not be removed and must be fully legible at all
times.
The operating company must stri ctly observe the applicable
national regulations relating to the installation, function testing,
repair and maintenance of electrical products.
1.2
Warnings
The warnings in these instructio ns are structured as follows:
DANGER
The signal word "DANGER" indicates an imminent danger.
Failure to observe this informat ion will result in death or
severe injury.
WARNING
The signal word "WARNING" in dicates an imminent danger.
Failure to observe this informat ion may result in death or
severe injury.
CAUTION
The signal word "CAUTION" in dicates an imminent danger.
Failure to observe this informat ion may result in minor or
moderate injury.
NOTE
The signal word "NOTE" in dicates useful or important
information about the product.
The signal word "NOTE" is n ot a signal word indicating a
danger to personnel. The signal word "NOTE" can also refer
to material damage.
1.3
Intended use
Positioning of pneumatically controlled actuators; designed for
mounting on linear and part-turn actuators.
The device is designed for use exclusively within the stated
values on the name plate and in the data sheet.
— The maximum operating temperature must not be
exceeded.
— The permissible ambient temperature must not be
exceeded.
— The housing protection ty pe must be observed.
1.4
Improper use
The following are considered to be instances of improper use
of the device:
— For use as a climbing aid, e.g. for mounting purposes
— For use as a support for extern al loads, e.g. as a support
for piping, etc.
— Material application, e.g. by painting over the name plate
or welding/soldering on parts.
— Material removal, e.g. by spot drilling the housing.
1.5
Warranty provisions
Using the device in a manner that does not fall within the
scope of its intended use, disregarding this manual, using
underquali
fi
ed personnel, or making unauthorized alterations
releases the manufacturer from liability for any resulting
damage. This renders the manufacturer's warranty null and
void.
