V2 ELETTRONICA City1, Instruction Manual

Page: 22 / 74

ENGLISH
44 44
City1 FUNCTION TABLE
DISPLAY DATA DESCRIPTION
DEFAULT
SCor
DEFAULT
AntE
MEMO
DATA
dEF. no It does not load the V2 standard data no no
SCor Predefined programming for a typical sliding gate.
AntE Predefined programming for a typical two-door gate
t.AP1 0.0" ÷ 2.0' Gate 1 opening time 22.5" 22.5"
t.AP2 0.0" ÷ 2.0' Gate 2 opening time 0.0" 22.5"
t.APP 0.0" ÷ t.AP1 Opening time of pedestrian gate 6.0" 6.0"
t.Ch1 0.0" ÷ 2.0' Gate 1 closing time 23.5" 23.5"
t.Ch2 0.0" ÷ 2.0' Gate 2 closing time 0.0" 23.5"
t.ChP 0.0" ÷ t.Ch1 Closing time of pedestrian gate 7.0" 7.0"
t.C2P 0.5" ÷ 2.0' Leaf 2 closing time during pedestrian cycle no 2.0"
no - Function disabled
r.AP 0.0"÷ 2.0' Gate delay during opening 1.0" 1.0"
r.Ch 0.0" ÷ 2.0' Gate delay during closing 3.0" 3.0"
t.SEr 0.5" ÷ 3.0" Electrical lock operation time no 2.0"
no - Lock is not energized (it corresponds to 0)
t.ASE 0.0" ÷ 2.0' Lock advance time 0.0" 1.0"
t.inv 0.5" ÷ 3.0" Backlash time no no
no - Backlash disabled (it corresponds to 0)
t.PrE 0.5" ÷ 2.0' Pre-flashing time 1.0" 1.0"
no - Pre-flashing disabled (it corresponds to 0)
Pot1 30 ÷ 100% Motor 1 power 60 60
Pot2 30 ÷ 100% Motor 2 power - 60
SPUn no/Si Start off no Si
t.P.So 0.5" ÷ 3.0" Slowed down starting time 1.5" no
no - Slowed down starting disabled
t.raL 0.5"÷22.5" Slow down time 2.0" 2.0"
no - Slow down disabled
t.CVE 0.0" ÷ 3.0" Fast closing time after slowing down during closing 0.0" 1.0"
St.AP Start in opening PAUS PAUS
no - Start command is not available
ChiU - Command close gate
PAUS - Stop the gate and goes in pause
St.Ch Start in closing StoP StoP
Stop - Start command stop the gate
APEr - Start command open the gate
St.PA Start in pause ChiU ChiU
no - Start command is not available
ChiU - Start command closes the gate
SPAP Pedestrian in opening PAUS PAUS
no - Pedestrian start command is not available
ChiU - Pedestrian start command closes the gate
PAUS - Gate goes in pause
Ch.AU Automatic closing no no
no - The automatic closing is not active (it corresponds to 0)
0.5"÷ 20.0' - The gate closes after the setup time