V-ZUG UnimaticWash V4000, Operating Instructions Manual

Page: 27 / 56

5 Washing
5.8 End of programme
Loosening up the washing
Shortly before the end of the programme, the washing is loosened up. This takes about
1–2 minutes. If steam anti-crease has been selected, the loosening-up period is exten-
ded to about 60 minutes to further prevent creasing.
Touch the button to unload the washing at any time during the loosening-up
phase.
With «Automatic door opener OFF»
– When the programme has finished, the follow-
ing appears in the plain text display for
10 minutes:
End of programme
▸ Touch the button.
– The appliance door opens and the washing can be unloaded.
In the event of a power failure, the appliance door can only be opened using the
emergency door release.
With «Automatic door opener ON»
– The appliance door opens automatically at the end of the programme.
– The washing can be unloaded.
With «Stop after rinsing»
The washing remains lying in the water after the final rinse. The water must be drained
off before the washing can be unloaded.
▸ Touch the
button 1×.
– The washing is spun at the spin speed set for the programme selected.
▸ Touch the button 2×.
– Draining without spinning.
With the hygiene recommendation display
Hygiene recommendation:
at least 60 °C programme
/
or select appliance
hygiene
It is common nowadays to select programmes with temperatures below 60° C in order
to save energy. These achieve perfectly good results with lightly soiled everyday wash-
ing. Washing almost exclusively with low temperatures will result in the formation of foul
smelling coatings in the appliance. To avoid this a «hygiene recommendation» appears
when it is recommended that one of the following steps be taken for hygiene reasons:
▸ With one of the next wash cycles carry out a wash with at least 60°C.
Or:
▸ Unload the washing.
▸ Touch the
1× button.
– The «Appliance hygiene» programme starts.
27