16
bottom with overlapping strips until you reach the top of the area, sprinkling the whole are with
detergent. This system is known to avoid dripping of detergent onto dry surfaces, the residue of
which could remain even after rinsing.
In order to avoid the formation of deposits or crusts, at the end of operation it is advisable to pass
clean water through the pump for a few seconds.
Important Advice
To safeguard the environment, we advise that only authorised detergents are used, that the
recommendations of use and dosage are observed on the product labels, that detergent is used
sparingly and remember that use of inappropriate detergent, as well as damaging the environment
can damage the hot water cleaner as well as the objects being cleaned.
USE DETERGENTS WHICH ARE OVER 90% BIODEGRADEABLE
.
Before sprinkling detergent over varnished areas with delicate colours, make sure that the surfaces
to be treated are not hot, that the detergent has not dried and that the concentration of water /
detergent is correct.
IMPORTANT: Rinse well.
Upon completion of operation, shut down the machine then squeeze the pistol lever until the residual
water pressure has been expelled.
LUBRICATION OF THE PUMP
For the models 200.15 we recommend:
V-TUF Pressure Lube PL100 – OIL CAPACITY 1.2 litres
For the models 100.12 we recommend:
V-TUF Pressure Lube PL100 – OIL CAPACITY 0.42 kg
You should change the oil after the first 50 hours of use, and after each subsequent 500 hours of
operation.
Summary of Contents for VTS1210HPC XL
