V-TUF VTS1210HPC XL, Operator'S Manual

Page: 28 / 38

28
RUNNING
Connecting to the electric current, the current light illuminates.
Pressing the ON/OFF button to On will start the machine which will run accordingly:
S_LIN = Electric current light
S_TSI = TSI LIGHT (Total Stop)
S_H20 = Lack of water light
S_GAS = Lack of fuel light
STATE1
PTP->NO (0 Bar)
PDV ->NC (0 Bar)
High pressure water cleaner “closed down”
STATE 2
Pistol (lance) open
High pressure water cleaner “in operation”
PTP->NC (200 Bar)
PDV->NO (200 Bar)
MOT=ON
BV= On after 1 second (*)
EVG= On after 3 seconds (**)
STATE 3
Pistol (lance) closed
PTP->NO (0 Bar)
PDV->NO (200 Bar)
EVG= OFF (**)
BV= Off after 14 seconds (*)
MOT= Off after 14 seconds
S_TSI= On after 14 seconds
To restore the TSI system, it is necessary to verify the conditions of state 1 (pistol/lance open) followed by
state 2 etc…
The machine also manages the lack of fuel (PPG), 14 seconds after detection the EVG (**) and the BV (*)
will switch off. 1 second later the relevant warning light (S_GAS) will illuminate and the system will be
blocked.
To restore it, you must shut the machine down and turn it on again.
The machine is also supplied with a time-out feature so that if the machine is not used for 40 minutes, it
shuts itself down and the machine is blocked (shown by the TSI light illuminating). To restore normal
operation, it is necessary to turn the machine off and start it up again.
Finally , the machine is equipped with a particular algorithm for recognising water leaks so that if it should
detect 10 consecutive drips in less than 3 seconds, the machine will shut down and the TSI light will
illuminate. To restore operation it is necessary to turn the machine off and start it up again.
(**) EVG works only in hot water mode, with the water temperature thermostat.
(*) BV works only in hot water mode, independently of the water temperature thermostat.