V-TUF VTS1210HPC XL, Operator'S Manual

Page: 19 / 38

19
REGULATION OF THE STARTER ELECTRODES
For optimum machine performance, it is necessary to check that the starter electrodes are always arranged
in the correct way, as indicated in the diagram.
Checking the height in relation to the level of the head of the fuel nozzle.
Resting the control bar on the head of the diesel nozzle, as indicated in the diagram, check that the two
electrodes do not go beyond the main wire.
ATTENTION
This work should be undertaken by an authorized technician.
The starter electrodes should be replaced after every 400 hours of operation.
Checking the distance between the electrodes. Resting the control bar on the head of the diesel nozzle, as
indicated in the diagram, check that the two electrodes are both in contact with the surface of the control
bar.
Checking the distance between the electrodes and the centre of the head of the diesel nozzle. Resting the
control bar on the head of the diesel nozzle, and keeping its internal surfaces in the centre, as shown in the
diagram, check that the two electrodes are in contact with the external surface of the control bar.
It is recommended that you always check with your re-seller, nearest help centre or qualified and
authorized technician regarding maintenance details, repairs and / or adjustments. The manufacturer does
not accept any responsibility or liability for any damages caused by use of the machine with parts which are
not perfectly regulated, or with parts which are damaged or worn out.
Cleaning of the hot water high pressure cleaner
Wash only with neutral products and water: then dry carefully so that you eliminate any collections of
water.
The plastic parts can be cleaned with a normal wash. Should any traces of dirt remain, it is recommended
that you use specific products, carefully observing the usage instructions.
ATTENTION
Do not use products containing solvents, methanol or hydrocarbons.