RAPID-VSC-DEM
Instructions - user maintenance manual
-
©02/20 Rev:1.0
/TRANSLATION OF THE ORIGINAL
INSTRUCTIONS
Page 43
CHAPTER 15 - D
ISPOSAL
15.1 P
RESSURE WASHER DISPOSAL
(
DEMOLITION OF THE MACHINE
)
If you decide to scrap the machine, to prevent it from posing an hazard to people and the environment, it is
necessary:
•
disconnect the machine from the mains power supply and from the water supply network
•
cut the power supply cable and piping
•
remove the wand and gun
•
cutting electrical wiring
•
Disassemble and disconnect the pump and engine from each other
•
destroy the identification plate of the machine and that of the pump and engine unit.
•
Sheaths, flexible conduits and components made of plastic or non-metallic material must be dismantled and
disposed of separately.
•
Electrical components such as switches, power supplies, cards, etc., must be dismantled for reuse if they are still
in good condition or, if possible, overhauled and recycled.
•
The structure, and in any case all the metal parts of the machine, must be dismantled and grouped by type of
material. The various parts thus obtained can then be dismantled and melted down to allow the recycling of the
original machine material.
All fluids used in the machine's piping must be removed and disposed of in accordance with current regulations.
The machine must be dismantled by specialised personnel.
The components of the pressure washer must be disassembled and separated according to the nature of the
materials that compose it, and must be disposed of in compliance with the laws in force regarding the collection
and separate disposal of waste.
If the machine is dismantled, comply with the anti-pollution regulations in force in the country of use.
Failure to comply with these provisions can cause considerable damage to people, animals and the
environment.
The End-customer is responsible for any failures and non-compliance with these rules.
15.2 D
ISPOSAL OF CONSUMABLES OR MATERIALS SUBJECT TO WEAR AND TEAR
With regard to the disposal of parts subject to increased wear, which may have been replaced, no particular
recommendations are necessary other than to follow the regulations in force at the place of operation of the machine
regarding the separate collection of waste.
Waste oil must be disposed of through the waste oil consortium, in accordance with the law.
15.3 .
D
ISPOSAL OF PACKAGING
Packaging materials and maintenance waste should be collected separately and sent to specialised waste disposal
companies (wood, plastic, metal, etc.) and not left within reach of children or animals.
.
