24
Operating instructions VisionLine
24
4 Operation
The camera system is designed for continuous operation and can therefore remain switched on conti-
nuously.
NOTICE
During the operation of the machine, it is not allowed to interrupt the compressed air
supply of the camera systems VisionLine RWC and VisionLine EAC.
4�1 Commisioning
CAUTION
Commissioning is only authorized by qualified personnel. During commissioning there is
a risk of starting or rotating parts. Avoid contact during the operation.
When the assembly has been successfully completed, commissioning can begin.
■
First pressurize the system with compressed air: Set the air service unit via the pressure regulator
so that the pressure gauge shows a pressure of approx. 0.3 to 0.5 bar.
■
Make sure that both, the control box and the playback device, are connected to the power supply.
■
Connect the control box and a suitable playback device (with the HDMI input) by plugging an
HDMI cable into the appropriate ports of the respective devices. Make sure the HDMI connector
on the control box snaps into place.
■
Now switch on the playback device: probably you have to set the signal input to „HDMI“ on
themonitor. Instructions for this are provided by the manufacturer of the playback device you are
using.
■
Now switch on the camera system: To do this, set the rocker switch on the bottom of the control
box to „I“.
■
After powering up the system on the control box, it may take up to 30 seconds before the first
footage is transferred to your monitor.
Please observe the following notes when using the optional operating unit:
If you have performed all of the steps listed above for commissioning, you must also make sure,
when that the key switch „Maintenance“ on the operating unit is in the „on“ position, when using an
operating unit.
The control unit also gives you the option of turning the integrated power LEDs on or off as needed.
To do this, press the „Lighting on / off“ push-button on the operating unit. After turning on the switch,
the power LEDs in the camera body light up and the switch is highlighted with a green light.
The optional control unit is only available for the VisionLine RWC camera system.
