UWE W75 Series, Operation Manual

Page: 8 / 21

FUNCTION DEFINITION AND SETUP
●
Press and hold
​
TARE
​
and press ON/OFF,
​ ​
display shows
​
F1
●
Use
​
TARE
​
(next) or
​
MR
​
(previous) to scroll through the internal setting menu, and press
​
MODE
to enter the setting.
●
Use
​
ZERO
​
in sub-setting menu to scroll through available options. Press
​
MODE
​
key to confirm
and exit.
●
Press
​
ZERO
​
and display will show
​
SAVE
​
. If setting was changed, user can either press
​
MODE
​
for
yes to save the changes made or press
​
ZERO
​
for not to save the changes.
CAUTION: BEFORE LEAVING THE INTERNAL SETTING, ALL CHANGES MUST BE SAVED OTHERWISE
THE SCALE WILL STILL FUNCTION UNDER THE OLD SETTING.
Offset Value & Function Key Test (F1)
Under this function scale will show the offset value and be able to check the function of each key.
LCD Segment Check and Backlight Adjustment (F2)
Under this function all segments and indicators will be in flashing mode as well as backlight for user
to check if function properly.
Press
​
ZERO
​
to adjust the backlight brightness. There are five settings, press
​
MODE
​
to confirm
setting. Backlight brightness also has 5 level selections for optimal viewing.
Auto Power Off (F4)
Under this function, user can select auto power off timing among 5 minutes, 10 minutes, 15
minutes and 20 minutes or disable the function. There are 5 settings, the numerical digit means the
minutes to power off when scale idles.
​
ALL.on
​
means the Scale will never automatically turn off
unless manual intervention.
5.oFF -> 10.oFF -> 15.oFF -> 15.oFF -> ALL.on
Transmission Protocol (F5)
Under this function, user can select the transmission interface, speed, mode and format for RS-232
and also the communication protocol.
When display shows
​
F5
​
, press
​
MODE
​
to enter the function
First level selection: nonE / rS232
Second level selection: bAUd / ProtL
Selection under
​
bAud
​
: 2400 / 4800 / 9600 / 19200 / 38400 / 115200bps
Selection under
​
ProtL
​
: n.8.1 / E.7.1 / o.7.1 / E.8.1
use
​
MODE
​
key to enter,
​
ZERO
​
to change,
​
MODE
​
key to confirm
Terminology:
nonE
​
: no data output
bAud
​
: baud rate
rS232
​
: data output through RS-232
ProtL
​
: transmission protocol