5. INSTRUCTION TO USE
The W75 series are equipped with user friendly functions, including preset tare, manual tare, auto
tare, automatic continuous tare, simple counting and memory plus functions. It also comes with
interfaces including RS-232 and RS-485 for data output and 4 channel relay output for controlling
purpose. (Optional) Furthermore, the gravity compensation in the internal function also allows user
to calibrate the weighing result correctly without involving actual mass.
Before start weighing:
a. Make sure load cell cable is connected to indicator
b. The scale is placed on a solid surface
c. Use adjustable feet and referring to the bubble level to make sure scale is in a level position
d. Power on the scale and wait for the counting down
e. Scale is in zero weight status and display showing zero indicator and stable indicator
f. If Zero indicator is not on, press
ZERO
to set the display to zero
g. If zero weight status cannot be obtained, re-install the platter again
h. If stable indicator is not on, check the environment and relocate the scale in a stable
environment
5.1
WEIGHING UNIT SELECTION
Press
MODE
to switch between metric, imperial and piece counting mode.
5.2
TARE FUNCTION SETTING
This indicator equips with auto tare, continuous tare (please refer to
F9
of internal setting) and
manual tare.
a. If auto tare function is enabled, the first weight being placed on platter will be automatically
tared
b. If continuous tare function is enabled, each weight being placed on platter will be automatically
tared
c. If manual tare is needed, place the load/container on the platter first and press
TARE
to tare off
the weight. After weight is tared,
NET
indicator will appear indicating the weight showing on
display is net weight
d. If preset tare is needed, press and hold
TARE
and display will show
PrE.Tr
and enter preset tare
value setup
e. Use
TARE
to shift the flashing cursor and
ZERO
for increment to adjust the preset tare value
f. When desire value is entered, press
MODE
to confirm and save the change
g. Scale will exit the function and return to normal weighing mode while
NET
indicator and
PT
indicator appears
h. The
ZERO
indicator points out the negative value shown means the platter is at zero weight
status
i.
When the goods is placed on the platter with a positive value shown, this indicates the actual
weight of the goods
How To Clear Tare Function (auto tare, automatic continuous tare, manual tare, preset tare)
a. To clear auto tare, remove the initial weight/load from the platter and
NET
indicator will turn
off. Press
ZERO
to return to zero weight status if
ZERO
indicator does not appear
b. To clear continuous tare, remove all loads from platter and
NET
indicator will switch off. Press
ZERO
to return to zero weight status if
ZERO
indicator does not appear
c. To clear manual tare, remove everything from platter and press
TARE
, the
NET
indicator will
turn off. Press
ZERO
to return to zero weight status if
ZERO
indicator does not appear
Summary of Contents for W75 Series
Page 21: ...DISPLAY SEGMENT DEFINITION ...
