or overloading the scale may cause
damage to the weight sensor inside.
It is a good practice to remove all load
from platter when not in used. This would
prolong the lifetime of weight sensor.
7.7 WEIGHING FUNCTION
a. Before weighing, make sure that the Zero
Status Sign is on.
b. Press
MODE
until the required weight
unit appears.
c. Place subject matter on platter and the
weight of it is displayed.
For best weighing result, refer to
general specification table for
recommended minimum weight to be
applied.
7.8
COUNTING FUNCTION
7.8.1
Turn scale on. Press
MODE
until the PCS
sign appears. Make sure that the Zero
Status Sign is on.
7.8.2 Sampling
Sampling is the first step of counting
transaction. By means of sampling
process, the unit piece weight is
obtained. The unit piece weight forms
the foundation of quantity calculation.
a. If a container is used, place the
container onto the platter first then
press
TARE
to tare off the weight of it.
b. Place a sample size with known quantity
onto the platter. The number of the
sample size must equal to one of the below
value:
5, 10, 20, 50, 100, 200, 500 or 1000pieces
c. Press
HI/LO/SAMPLE
until 5 PCS
appears.
d. Press
TARE
until corresponding sample
number appears.
e. Press
SET
to confirm. The unit piece
weight is obtained and scale is now ready
for counting transaction.
Hint: It is usually true that the more the
sample size, the more accurate the
subsequent counting result.
NOTE
: For best counting result, refer to
general specification table for
recommended minimum piece weight.
NOTE
: An error sign will appear if the unit
piece weight is less than the feather
unit weight. Refer to Appendix E for more
