Manufacturer: UVI Group Corporation GSM Car Alarm System with GPS Car Tracking (GPS-118V)
-17/18-
alarm phone numbers.
2. Check whether there is balance in SIM card.
When there is no alarm, the system call
alarm phone numbers.
Check the sensitivity of the shock sensor, and adjust it to a
moderate level.
When you use the dialer to dial a number,
there is no voice in the speaker.
Check whether the connection plug is in correct place.
The central lock doesn’t work or is abnormal.
1. Check the actuator.
2. Check the wire, fuse.
3. Read the installation instruction and wiring connection for
central lock.
The car cannot be started. /System give
notice that it is started successfully, but the
system is still trying to start the ignition.
1
、
The hand brake test line is not connected properly.
2
、
The lamp test line of engine is not connected properly.
The siren beeps all the time and cannot be
released by remote control after this system
is installed.
1. Check whether the wire is connected correctly.
2. Check whether the fuse of the mainframe is burned out.
3. Check whether the model of mainframe and that of remote
control is the same.
Parked and armed, this system alarms when
a truck or a cart passes by.
Check and adjust the sensitivity of the shock sensor.
10. Special Notice
As the signal from remote control of the car is transmitted via RF, the control distance of
remote control may be affected by buildings, geography conditions, and weather sometimes.
Read the Operating Instruction and wiring connection carefully before the installation. Please
make out electro circuit of car first.
The mainframe should be installed away from high temperature, humidity and other electronic
items. Plug the wire plug into the mainframe, and wrap the wire top with a paste-tape. Please
take out the control wires, such as power supply wire, ignition wire, and light wire, door open
signal wire. If there is no door open signal wire, it is needed to install corresponding sensor
switch.
The power supply wire should be installed after all other wires being installed. Please wrap all
the connection point with pastern.
It is suggested that the antenna should be installed close to the windshield. Any antenna
folding, cutting and grounding is prohibited.
The shock sensor should be pasted close to the car. Adjust the sensitivity to a good level.
If the remote control distance shortens and the LED on remote control is dim, please change
the battery.
When battery of the remote control is low, please change it in time. Please choose high
capacity alkaline battery. Pay attention to the anode and cathode of the battery.
The manufacturer preserves the authority to change the design and function without
preannouncement.
Warranty Card
IMPORTANT! This card should be completed by selling dealer. To receive product support service,
technical updates and upgrades, please keep this card after purchasing.
