Manufacturer: UVI Group Corporation GSM Car Alarm System with GPS Car Tracking (GPS-118V)
-10/18-
again, this system will try to start the engine. If it succeeds, siren will beep once. Otherwise, the
siren will beep 3 times. After being remote started, the engine will be on for 8 minutes. Press
to
stop the engine.
Attention! Before the engine is remote started, the user should make sure that the gear is in
neutral place and the hand brake is should be pulled on. To remote start the air conditioner, it is
should be on before the ignition is turned off. The engine will be off after 8 minutes. If it is remote
started by remote control, any brake and key spinning in ACC will cut off the ignition.
3.34. SMS Control Order
The user can send specific short message to the system to control the car, and also a short
message will be back to tell the user whether the operation is done successfully/
Short message are as follows will be displayed on the alarm phone numbers.
Message back
Message
Function
Successful
Failed
Arm
Remote arm the car.
Arm Successfully
Failed
Disarm
Remote disarm the car.
Disarm Successfully
Failed
Start
Remote engine start.
Start Successfully
Start
Failed
Stop
Remote stop the engine.
Stop Successfully
Failed
Phonelist
List all the phone numbers that have been set in
this system.
Phoneclear
Clear all the phone numbers that have been set in
this system.
Phone1clear
Clear phone number 1.
Phone1clear;2cle
ar
Clear phone number 1 and 2.
If a password has already been set into this system, the user should put the password before the
first letter. For example, send“****** Arm#” to arm the car. If there is no password, the message
should be “_Arm#”. If do not set the password yet, it must keep a blank before the first capitalized
letter. If set the password, it must keep a blank before the password.
If no phone number is in this system, the returned message will be “1), 2), 3)”.
3.35 GPS function
3.35.1 GPS message in state of alarming
When the system alarmed, the registered alarm phone will receive the SMS with status of
alarm, latitude, longitude, velocity and direction, e.g.
Door open,
N(S)XX.XX.XX
E(W)XXX.XX.XX
（
means XXºXX'XX"
）
VX.XX
DXXX.XX
They mean latitude (N/S), longitude (E/W), velocity (V), direction (D) respectively.
3.35.2 Check the location of car in real time
The user can send specific short message to check the car’s status any time and any
where
e.g.: *P#, if the password already been set, the format of check is: password*P#, the system will
send a message back to user with GPS message, e.g.:
N(S) XX.XX.XX
E (W) XXX.XX.XX
（
means XXºXX'XX"
）
