UTT Technologies Hardware Installation
http://www.uttglobal.com Page 6
1.3 Installation Requirements
The following items are required for installation:
1) Broadband Internet connection
2) Tools and equipment
(1) Broadband modem (optional)
(2) PC with an Ethernet card and TCP/IP installed
(3) Network devices like hub, switch, wireless access point
(4) Network cables
(5) Screwdriver
(6) Power outlet
1.4 Installation Procedure
Follow these steps to install the Device on a flat surface such as a bench:
1) Make sure the Device is powered off.
2) Place the Device upside down on a sturdy, flat bench with a power outlet nearby. Verify that the
bench is well grounded.
3) Remove the adhesive backing from the supplied rubber feet. Attach the four rubber feet to the
round recessed areas on the bottom of the Device.
4) Turn the Device over to make it right side up on the bench.
1.5 Connecting the Device
Before you install the Device, please make sure your PC can connect to the Internet through your
broadband service successfully. If there is any problem, please contact with your ISP for help.
After that, please install the Device according to the following steps. Don’t forget to pull out the
power plug and keep your hands dry.
1) Power off your PC(s), Cable/DSL modem, and the Device.
2) Connect the Cable/DSL modem to the Device’s WAN port.
3) Connect one end of an Ethernet cable to one of the LAN ports on the Device, and the other end
to a network port on a PC, hub, switch or wireless access point. Repeat this step to connect
more PCs or other network devices to the Device.
4) Connect the power cord to the power port of the Device. Then plug the other end of the power
cord to a grounded AC power outlet.