Chapter 2. Specification
5
2.2.3 CONNECT ADSL LINE
Use the ADSL (telephone) cable included with the Router to connect it to a telephone wall socket or receptacle.
Plug one end of the cable into the ADSL port (RJ-11 receptacle) on the rear panel of the Router and insert the other end
into the RJ-11 wall socket. If you are using a low pass filter device, follow the instructions included with the device or
given to you by your service provider. Access to the Internet for all workstations on the Ethernet LAN is provided through
the ADSL port. This is the physical connection for all devices using the Router to the Wide Area Network (WAN) or
Internet.
2.2.4 CONNECT USB CABLE
The CD-ROM shipped with the Router contains the USB driver software.
Insert the CD-ROM into the CD drive.
Within a few seconds, you should see a window that offers the following options: Install UT-300R2U, Quick Install Guide,
View Manual, Install Acrobat Reader, and Exit. If you do not see this auto-run pop-up window, explore the CD-ROM and
double-click the setup application file
autorun.exe
or find the file
Setup.exe
in the folder labeled
USBDRIVER
and
double-click it to launch the installation software. The auto-run USB driver setup must be completed before connecting
the router to your PC with the USB cable. To install the driver follow these instructions:
1.
Click the
Install UT-300R2U
link in the to launch the USB driver installation software.
2. Click
Next
on the InstallShield window.
3. Click
Install
to begin the installation.
4. Click
Finish
to complete the InstallShield wizard.
When the USB driver has been installed, insert one end of the USB cable included with the Router into the
Router’s USB port. Insert the other end of the USB cable into a USB port on your PC. Connect the power adapter to the
power input at the back panel of the Router and then plug the other end of the power adapter to a wall outlet or power
strip. On the front of the device, the Power LED will turn ON to indicate proper operation. Insert the telephone cable
included with the Router into the ADSL port, and then connect the cable to your telephone line. Check the LED display
on the front of the Router to confirm that the connections have been made.
