Installation Guide
Roseberry Wall Mounted Washbasin Unit
Important Information
•
Check the product for any signs of damage and remove any protective film.
•
It is recommended that a technically competent installer undertakes installation.
•
It is the inst
aller’s responsibility to carry out a thorough assessment of the installation
environment (i.e. wall type/structure and the combined weight of the cabinet and basin) and
use appropriate fixings.
•
Care should be taken when drilling to avoid any hidden wires or pipes.
•
To prevent the cabinet falling from the wall this product must be fixed using the wall
attachment device and brackets provided.
Installation
Mark a horizontal line on the wall at the required height
X---X
. Ensure that the
wall brackets will fit inside the width of the cabinet and are equally spaced to
ensure even distribution of weight. Secure the wall brackets to the wall using
suitable fixings.
Hook the unit onto the wall brackets so that the spring locks the arm
into place.
Turn screws A to move the cabinet up and down on the wall. When the
cabinet is level, turn screws B to tighten the cabinet to the wall.
Drawer Box Removal and Replacement
To remove the drawer box, pull the drawer fully out and lift it upwards.
To re-fit the drawer box, pull the runners fully out, place the drawer
box on the runners and push it rearwards until it clicks into place.
Drawer Front Removal
Slide the slide the drawer side covers rearwards to expose the
screws. Using a crosshead screwdriver, turn the screws shown to
release the drawer front. Where there are two screws on each
drawer side, turn the top screw first followed by the bottom one.
Drawer Front Adjustment
Slide the drawer side covers rearwards to expose the adjustment
screws. To raise or lower the drawer front, turn the larger screws with
a crosshead screwdriver until adjusted as required. To move the
drawer front from side to side, turn the smaller screws. To adjust the tilt
of the drawer front, remove the caps from the tops of the drawer sides.
Use a cross-head screwdriver to adjust as required.
Care & Maintenance
Furniture should be regularly dusted with a soft cotton or micro-fibre cloth. For more thorough
cleaning, occasionally wipe your furniture with a soft cloth dampened with a mild detergent
solution. Surfaces should be thoroughly dried with a lint free cloth to prevent watermarks. Under
no circumstances should solvent cleaning agents, bleach or abrasive cleaning agents or cloths be
used. Spills should be removed immediately using a clean cloth. All bathroom furniture will
deteriorate through prolonged periods of exposure to high levels of condensation so bathrooms
must be adequately ventilated using suitable extraction. Failure to ensure adequate ventilation
may invalidate your guarantee. If it required to use the touch-up paint, ensure that the surface is
dry and clean and free from dust or oils. The paint should be applied using a slightly damp
sponge. Carefully dap the paint onto the required area and leave it to dry. Multiple coats may be
required to build-up the paint to give the required finish.
