When assembly is complete, turn the unit onto its legs and place in
the final installation position. Drill through the back rail and into the
wall. Secure the unit in place using fixings suitable for the wall type.
Re-fit the drawer box by placing it onto the extended runners and
pushing it back into the closed position until an audible click is heard.
Place the towel slats into the slots on the towel rail
supports.
Drawer Box Removal and Replacement
To remove the drawer box, pull the drawer fully out and lift it upwards.
To re-fit the drawer box, pull the runners fully out, place the drawer
box on the runners and push it rearwards until it clicks into place.
Drawer Front Removal
Slide the slide the drawer side covers rearwards to expose the
screws. Using a crosshead screwdriver, turn the screws shown to
release the drawer front. Where there are two screws on each
drawer side, turn the top screw first followed by the bottom one.
Drawer Front Adjustment
Slide the drawer side covers rearwards to expose the adjustment
screws.
•
To raise or lower the drawer front, turn the larger screws with
a crosshead screwdriver until adjusted as required.
•
To move the drawer front from side to side, turn the smaller
screws.
•
To adjust the tilt of the drawer front, remove the caps from the
tops of the drawer sides. Use a cross-head screwdriver to
adjust as required.
Care & Maintenance
Furniture should be regularly dusted with a soft cotton or micro-fibre cloth. For more thorough
cleaning, occasionally wipe your furniture with a soft cloth dampened with a mild detergent
solution. Surfaces should be thoroughly dried with a lint free cloth to prevent watermarks. Under
no circumstances should solvent cleaning agents, bleach or abrasive cleaning agents or cloths be
used. Glass or mirrored panels should be cleaned using a non-solvent based glass cleaner and a
soft cloth. Spills should be removed immediately using a clean cloth. All bathroom furniture will
deteriorate through prolonged periods of exposure to high levels of condensation so bathrooms
must be adequately ventilated using suitable extraction. Failure to ensure adequate ventilation
may invalidate your guarantee. If it required to use the touch-up paint, ensure that the surface is
dry and clean and free from dust or oils. The paint should be applied using a slightly damp
sponge. Carefully dap the paint onto the required area and leave it to dry. Multiple coats may be
required to build-up the paint to give the required finish.
