Electric Soladora CONVEY 260
www.utiform.com
departamento.té[email protected]
Tfno. + 34 96 570 29 82 fax: + 34 96 570 29 83
9
3
Transport
3.1
Safe-deposit special indications
•
If a change of the machine takes place in the work, the deposit of mixing and of transport they should
be empty and the pieces of the machine low pressure should not be.
•
To only use an appropriate vehicle of transport or traction with enough loads of tow and of support.
•
To hook the hook head correctly with the traction vehicle.
•
To move the tow for safe-deposit reasons for two people. To offer that he/she is always a person to the
reach to be able to help.
•
If it is new machines or after a change of wheels press the nuts of the wheels on the way after few
kilometres with the moment of marked rotation again.
3.2
Transport for crane
When moving the place machine with a crane, the machine has to go held in two points.
ATTENTION!
The suspension hole in the superior part of the machine is only foreseen for the
disassembly of the unit motor-compressor, it doesn't stop its use like support for elevation of the machine.
-
To retire or to tie all the loose pieces that could fall when lifting the machine.
-
It would be advisable that there was an in charge specialist that is near the driver of the crane or that it is
in contact with this for megaphone.
-
To hang the machine then to the crane.
-
To only use for the lift elevators and machinery of support of loads with capacity appropriate producer.
-
To control before if they are revised and approved according to the local safe-deposit norms.
-
If he/she gets up the machine or pieces of the machine with one or several elevation holes, it is
necessary to use load hooks, shackles. Not to place cables, chains or strings directly in the elevation
holes.
-
Not to never use bent load hooks, etc., and to tie them from such a way that is subjected to an effort
always on-line straight line with the axis of the support of loads.
-
Given the case, you can place a beam between the elevator and the load. You can also use two elevators,
keeping in mind that these cannot be inclined more than 30º against the vertical one. The supportive
capacity of an elevator diminishes if the force elevator doesn't lapse in a vertical way.
-
In any event, the machine in such a way that can be raised vertically, to assure and that it cannot rotate
neither to overturn.
-
To be careful with the load and not to work with too much impetus. The acceleration and deceleration
have to be inside some moderate limits.
-
Not to leave hung the load in the elevator.
-
To make sure that nobody is in the area of danger around the load.
Summary of Contents for Convey 260
Page 42: ...Zerlegung ...