Page 20/21
UTEK TECHNOLOGY (ASIA) CO., Ltd.
http://www.szutek.com
0755-27886063
5. If this window appears, it means that the virtual serial port software has been installed on your computer normally. Click
“Finish” to complete the installation.
C. Open the virtual serial port software
Run the virtual serial port software through “Start menu – control panel - COM port over TCP/IP”, as shown below. Select
the required COM port and click on “Map”, a new window named “Port setting” will pop up, enter the IP address of the
serial server, such as 192.168.1.247. Enter 1 for “Device port” (
note that based on what port the multi-port serial server is
entered, e.g. enter 5 for the fifth port of an 8-port serial server, and you can also create 8 serial ports at the same time,
when you just enter 1-8
); KeepAlive is the active time of the port and the typical setting is 300s; Status Report is typically
set to “immediately” for an instant connection. Then click “OK”. Configure other COM ports in the same way.
（
It’s very
important to press the “Save” button after finishing the required COM ports before you can use the virtual COM ports.
）
