Page 18/21
UTEK TECHNOLOGY (ASIA) CO., Ltd.
http://www.szutek.com
0755-27886063
i)
Can’t be connected as a TCP server
1. Make sure that there is no other PC connected to the corresponding port of the serial communication server. To do this,
enter into [Statistics] of the serial communication server, and view [Active TCP information]
2. If [Authentication] in [Specific parameters] is none
If the problem remains unsolved, please contact the manufacturer.
Chapter Six Accessories
a)
Modification of IP address
After the device is connected, start the attached software “upgrade” (as show in the figure below), select
“Server - search all devices” or click on the red circle in the following figure, and then you can view IP
addresses and basic information of all the UT-66XXM-I series devices connected to the network. Click
and select a device, change the IP address through selecting “Tool - Temporary change ip address”. The
IP address should be in the same network segment of the switch connected to the serial server, for
example, if the IP of the switch is 192.168.1.1, and then the IP address of the server should be
192.168.1.XXX.
b)
Creation of virtual serial port
1. Run the virtual serial port setup file “setup.exe”, the “Setup” window will pop up, click “Yes” to go to the next step.
