VS-MKII Control System
Chubb Fire & Security Pty Ltd
Technical Manual
Page 16 of 63
Step 5 - Saving changes
After you have set the dipswitches to the
desired positions, press and hold the
“PROG/SAVE” button for 3 seconds to
save
the new configuration (Fig. 25).
The system will now generate a fault
which is designed to prompt a user to
perform the next step.
Figure 25 - ‘PROG/SAV’ button
Step 6 – System reset
Press and hold the “SYSTEM RESET”
button for 2 seconds to clear the fault
and commit the setting change to the
modules memory (Fig. 26)
This step is required for each
configuration change.
Note: If at any stage you need to cancel
programming mode press the Channel
button once.
A system reset can also be activated via
the display panel by using the “TEST”,
“DELAY” and “DIM” push buttons.
To prevent accidental operation, the
‘delay’ push button must be pressed
prior to the other two buttons:
1. Press and hold the ‘DELAY’ button
2. Press and hold the ‘TEST’ and ‘DIM’
buttons
3. Wait 1 second.
4. Release all three buttons.
Figure 26 - SYSTEM RESET Module
Figure 27 - SYSTEM RESET Display
Notes:
