Utax LP 3230, Instruction Handbook Manual

Page: 159 / 189

7-62 Using the Operation Panel
HTTPS (SSL Server HTTPS setting)
HTTPS (HyperText Transfer Protocol Secure) is a protocol that adds
SSL data encryption, message authentication and a digital signature
function to the HTTP protocol used for data transfer between WWW
servers and clients.
S-HTTP is a similar protocol, but HTTPS differs in that it uses SSL.
The default setting is
Off
.
1
Press
Z
while
>SSL Server On >
is displayed.
>>HTTPS
appears.
2
Press [OK]. A blinking question mark (
?
) appears.
3
Select
On
or
Off
using
U
or
V
.
4
Press [OK].
5
Press [MENU]. The display returns to
Ready
.
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the
standard by the IETF for authentication and encryption in the third
network layer (IP layer).
It can be used with both IPv4 and IPv6.
The default setting is
Off
.
1
After entering the administrator ID and password, press
U
or
V
repeatedly until
>IPSec
appears.
2
Press [OK]. A blinking question mark (
?
) appears.
3
Select
On
or
Off
using
U
or
V
.
4
Press [OK].
5
Press [Menu]. The display returns to
Ready
.
Security Level (Security level setting)
Security Level
is primarily a menu used by service representative
for maintenance work. There is no need for customers to use this menu.
>>HTTPS
? Off
Note IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP
addresses.
Note Check with your network administrator when selecting
network settings.
>IPSec
>IPSec
? Off