![background image](http://html.mh-extra.com/html/usystems/edge-3/edge-3_o-and-m-manual_1064761009.webp)
Page 9
Installation
Electrical Installation.
The EDGE system is to be electrically installed in accordance with local and regional electrical codes.
Electrical supply to the EDGE System requires to be 100
-
130V or 200
-
240V 50/60 Hz from a 10A dedicated
branch circuit protected supply.
Electrical connection to the EDGE system is made via the EMS located within the cabinet to an IEC 60320
-
1 C
-
14
fused appliance inlet.
**The Voltage range input is dependent on the Fan module configuration. (Refer to model identification/rating
label & the voltage
“
INPUT
”
marking located on the rear panel of the EMS.
Rear panel of EMS showing Voltage configured for 200
-
240V
Input Voltage range
100
-
130V / 200
-
240V, 50/60Hz, 5A max (Voltage input model dependant)**
Fan Module Voltage
Refer to EMS Rear panel & model Identification rating for configuration
WARNING
The EDGE
-
3 equipment is configure for either 100
-
130V fans or 200
-
240V dependant on the fans fitted, this
will be indicated to the rear of the EMS rating label. Reference image below.
The EDGE System requires a dedicated Power Source.
An approved power cord type to a maximum of 3m in length should be used to power the EDGE System to
ensure continued compliance.
Cables to be routed to avoid damage to the cables and prevent trip or other hazards.