Page 39
Sensor Names
The table displays each sensor assigned to the EMS and provides the ability to name each device. To change the name, select the
text field and type what is required. A good example would be to name a contact sensor in the front to
‘
Front door
’
which will
show on the dashboard.
SNMP
Trap Receiver
Specifies the destination to which the EMS should send SNMP traps.
Type
The type of trap to send. The EMS sends SNMP v2c Inform traps.
Trap Receiver IP Address
Enter the IP Address of your SNMP Trap Receiver.
Leave blank to disable traps.
Trap Community
Enter the community string to be sent in SNMP traps.
Actions
Select the save icon to save the settings.
SNMP v3 Users
The table defines users who are granted access to the EMS for SNMP operations. The details of the relevant user should be
entered into the SNMP client application in order to access the EMS.
Name
The SNMP user name. Two users are defined:
ems
-
ro
for read
-
only access;
ems
-
rw
for read
-
write access.
Level
The security level to be used for SNMP operations. This can not be changed from the pre
-
set authentication and privacy.
Auth Protocol
The protocol to be used when authenticating the user. Select the from the list.
Authentication Passphrase
The passphrase required to authenticate SNMP requests for this user. An authentication passphrase is required.
Leave the passphrase blank to deny access for the user.
Priv Protocol
The protocol to be used for data privacy. Select from the list.
Privacy Passphrase
The passphrase to be used for data privacy. If left blank the Authentication passphrase will be used.
Actions
Select the save icon to save the settings for the SNMP v3 user.
Note:
when changing any user parameters, please also type an authentication passphrase into the field provided, even if a
passphrase is already set, otherwise access will be disabled for the user.