USTER HVI1000, Instruction Manual

Page: 118 / 238

USTER®
HVI 1000
Instruction Manual
Uster Technologies, Inc. Chapter 6
(3/08) System Testing
-
Page 6-24
9 Sample Testing Procedures
There are four (4) main modules in system testing:
1. Bale ID
2. Micronaire (MIC)
3. Length/Strength (L/S)
4. Color/Trash (C/T)
All data and measurements are incorporated into these module tests.
Testing can take place in the above listed order
(though other sequences
of testing can be used)
.
9.1 Bale ID
This is the bale identification number. The field can contain up to forty
(40) alphanumeric characters of information. When the system is ready
for the entry of a bale ID, the Bale ID box is
GREEN . The bale ID can
be typed in manually, by clicking the Enter Bale ID button, or can be
scanned in using a bar code reader.
1.
To enter the bale ID via a bar code reader, hold the bale tag with
the code facing up.
2.
Slide the tag toward the bar code reader until the beam is
centered over the bar code on the tag.
3.
When the code has been read, the bar code reader beeps and the
Bale ID is displayed on the screen.
4.
Check the Bale ID field to see that the identification number is
displayed. If it is not, try again.
Once the Bale ID is entered successfully, it is displayed on the right-hand
side of the screen. This ID indicates the bale in testing.