USTER HVI SPECTRUM, Instruction Manual, Page: 92 / 230

USTER
® HVI SPECTRUM
Instruction Manual
Figure 6-15: Reset Tolerances Tab
4. The R
ETEST
T
OLERANCES
tab allows the range between the
maximum and minimum values of a sample to be measured. If the
difference between the test values is greater than the retest
tolerance, the operator is notified by a warning message. The
sample may be re-tested at this point. These tolerances are used to
indicate a
two-sided bale , which is a bale that may consist of
two different lots of cotton (possibly from different growing areas).
Note:
This only applies if you run 2 or 4 tests per sample.
5. To begin, click in the box located to the left of Retest Off/On .
6. Enter the actual retest tolerance amounts in each field and select
the
A
PPLY
button to continue making changes to the System
Configuration.
7. Select the OK button to save the changes and exit the screen.
Uster Technologies, Inc. Chapter 6
Configurations • Page 6-16