22
1000033244-00
4. Instructions for use
4-4-1. Connection with personal computer
(1) Start up the communication software.
- Start up the PC communication software and setup the connection.
- Reference the operating manual for the software you are using for how to set
it up.
Important
When using software that can be set for local echo set this function to
off. (The UIT-250 will return an echo)
(2) Start the serial communication function of the UIT-250.
- The following 2 methods can be used depending on the usage conditions.
•
If the cable that came with the unit is connected prior to start of measure-
ment and measurement is performed using UVD-S*** or UVD-TK the fol-
lowing method is recommended.
1) Connect the PC and UIT-250 with the serial communication cable.
2) Turn on the UIT-250.
3) Push the
switch on the UIT-250 three times.
-
is indicated on the display monitor of the UIT-250
showing that communication can be performed.
- A prompt ">" is shown in the PC communication software.
•
If the cable that came with the unit is connected while the UIT-250 is on
and the UVD-C*** is used and the data measured for the irradiance distri-
bution inside the conveyor is output the following method is recommended.
1) Turn on the UIT-250 and perform the various measurements.
- Do not output the distribution.
2) Connect the PC and UIT-250 using the serial communication cable.
-
is indicated on the display monitor of the UIT-250 and
communication can be performed.
When communication starts, pushing the Enter key on the PC returns the prompt
">".
If the prompt is not displayed, check the communication settings.
