Midori
™
UDC Portable Spot Cure
www.ushio.com
10
Charging the Batteries
1. Plug the AC adapter into a wall outlet.
2. Connect the AC power adapter to the DC IN jack located at the top of the charger.
Make sure no battery is installed. The LED indicator will turn green when the charger
is ready.
3. Slide the battery into the charger, making sure the negative side of the battery is
inserted into the charger first against the spring contact. The LED indicator will turn
RED when the battery is charging.
– LED indicator solid red light indicates batteries are charging and not ready for use.
– LED indicator solid green light indicates installed batteries are fully charged and
ready for use.
4. When battery has been fully charged, pull the battery out of the charger and unplug
the AC adapter from the charger.
WARNING!
USE ONLY APPROVED BATTERIES.
Use only pairs of fully charged batteries. Do not mix newly charged and
depleted batteries.
Never mix rechargeable battery with non-rechargeable batteries.
Do not incinerate, disassemble, overcharge or short circuit the battery.
Do not expose the battery to high temperatures above 122ºF/50ºC.
CAUTION!
The batteries should be removed from the
UDC PSC
unit if it will not be
used for extended time.
Battery
Standard Part:
Type:
Output Voltage:
Capacity:
Manufacturer/Part Number:
Battery Recharge Cycles:
Battery Charge Time:
RCR123A (Circuit Protected)
Lithium-Ion (Li-Ion), Rechargeable
3.0V
900mAh
Tenergy item #30201
500 charge cycles
4 hour
RCR123A Li-Ion Rechargeable Battery
