Page 29
SEED CONDITIONER
Maintenance
Section
F
Proper maintenance of the Seed Conditioner is critical for peak performance, reliability
and accuracy of this system. The following is a guideline for the type of maintenance
and servicing that should be performed on this unit. Your environment and uses may
require additional maintenance and service beyond this list to assure a reliable and
safe unit. The operator of this unit has ultimate responsibility to identify areas of
concern and rectify them before they become a hazard or safety issue. There is no
substitute for a trained, alert operator.
Do not put this unit into operation with any questionably
maintained parts. Poor performance or a hazard may occur.
GREASING
Use an SAE multipurpose high temperature grease with extreme pressure (EP)
performance. Also acceptable is an SAE multipurpose lithium-based grease.
1. Use a Maintenance Checklist to keep record of all scheduled maintenance.
2. Use a hand-held grease gun for all greasing.
3. Wipe grease fitting with a clean cloth before greasing to avoid injecting dirt and grit.
4. Replace and repair broken fittings immediately.
If fittings will not take grease, remove and clean thoroughly.
Also clean lubricant passageway. Replace fitting if necessary.
NOTICE
LUBRICANT
HUB CITY 90º BEVEL GEAR DRIVE
. Model no. 175. Lube quantity is .70 Pints.
HUB CITY GEAR LUBRICANT GL-90
. Part no. = 8-58-00-01-009.
For bevel gear drives with ambient temperature of 15-125º F (-9 to 52º C) and
operating temperature to 185º F (85º F).
Hub City GL-90 lubricant is a heavy duty industrial gear lubricant containing sulfur
phosphorous antiwear additives. Lubricants of this general type and meeting the
above specifications may be substituted where Hub City lubricants are recommended.
Lubricant selected must be compatible with nitrile rubber seals.
HUB CITY LUBRICANT
AGMA NUMBER
ISO-ASTM VISCOSITY GRADE
GL - 90
5 EP
220
