10
20
. After attaching the 2 ends of the I rails to
the side rails using the L brackets. Place 2
more L brackets from bag 4# on each I rail at
the seams of the face panels (4). With one
bracket on one side and one on the other,
secure the I rail to the back of the face pan-
els. Noweach I rail has 4 brackets on it and it
is secured to the side rails and the face panels
for maximum support.
21
. Locate the Steel Legs (LL & LR) in your
mechanism box. Stand at the top of the face
panels. The leg labeled LL goes into the big
hole on the Side Rail on your left (FL). Take
off all of the washers. (1) Place on only the
plastic washer with the big opening. (2) Put the
leg into the hole from the outside in. (3) Place
metal washer with small hole onto the leg
screw that is on the inside of the side rail and
put the nut on. You will need a 1/2” wrench to
do so.
22
. Locate the Steel Legs Connection Rod. On
each leg down by the rubber foot there is a hole.
Remove the bolt from each end on the Connection
rod and attach it to the legs by putting the bolt
through the holes in the legs and tightening it with
a 7/16” wrench.
Note:
There are no leg connecting rods for Horizontal or
King Beds
1)
2)
3)
1)
2)
3)
4)
