12
26
. Locate both mechanisms and lay flat
down on the floor. There is a top portion
to add springs and a bottom. Skip the inner
most top and bottom holes. (1&2) The
springs should be attached so that the hook
on the springs goes from inside to out and
(3&4) bend the spring back to get it into
the corresponding hole on the middle
piece.
Alternating putting springs on the top and
bottom part will make it easier. Meaning,
(5) place one on top, (6) then bottom , (7)
then top, then bottom, until you have all
the springs you need. Also, if you have an
odd number of springs, (8) the larger num-
ber will be on top. Example: Our queen
usually needs 7 springs. The top part will
have 4 and the bottom will have 3. Re-
member to skip the one inner most hole on
the top and bottom.
27
. (1) Place mechanism into the 5 holes in
the side panel. Make sure that the fork part
that sticks out of the mechanism is facing
out. (2) While holding the mechanism in
place use the countersink bolts located in
the hardware bag labeled “Mech” and
screw them into the mechanism from the
outside. (3) Use the allen wrench that we
provided you, also located in that hardware
bag. (4) Screw all 5 bolts in until they are
flush with the outside of the side panel.
1)
2)
3)
4)
5)
6)
7)
8)
1)
2)
3)
4)
5)
