6
5.
Locate Rear Toe Kick (D). It will be completely unfinished on both
sides. Place it on the dowel that is located at the bottom of the side
panel next to the notch that was cut out for the baseboard. Lock it in
with a cam.
Note: Rear toe kick is no longer used on vertical beds. Angle brack-
ets are used in place of the rear toe kick.
6.
Locate the Front Toe Kick (K). The back ill be unfinished and the
front will be finished. Place it on the remaining dowel located at the
bottom of the side panel closest to the finished edge. Make sure the fin-
ished face is facing outward and the finished edge is facing up towards
the bridge. Lock in place with a cam.
7.
(1&2)Lift the opposite side panel on
top of the side with the attached parts to
make the bed cabinet. (3-6) Secure with
cams and place structure on its face on
the floor on a soft clean surface. (7&8)
Then lift it against the wall so it sits flush
with the wall.
1)
2)
3)
4)
5)
6)
7)
8)
