6
System Components
Stenner Econ FP Injection System Installation Instructions
Note:
If there is sediment in the water, it should be removed prior to the injection system using a pleated filter and
or multi
-
media filter. Sediment could damage the water meter in extreme cases.
ACCESSORY CHECKLIST
Contents
3 Connecting Nuts 1/4"
3 Ferrules 1/4" or 6 mm Europe
1 Injection Check Valve
1 Weighted Suction Line Strainer 1/4"
1 20' Roll of Suction/Discharge Tubing
1/4" White or UV Black OR 6 mm White Europe
1 Additional Pump Tube 1 Installation Manual
MODES OF OPERATION DESCRIPTION
DRY CONTACT WATER METER
The pump will accept a dry (non
-
voltage) contact signal from a water meter and will run for a set time in response
to receiving a signal from the water meter. There are five pump operating time ranges. The control panel displays
the maximum pump operating time in seconds: 1 SECOND (0.1 to 1.0);; 5 SECONDS (0.5 to 5.0);; 10 SECONDS
(1.0 to 10.0);; 20 SECONDS (2.0 to 20.0);; 60 SECONDS (6.0 to 60.0).
Instructions:
Pre
-
Programming Requirements, steps A
-
D, pages 12 to 13.
Program Pump for SECONDS mode (water meter) steps 1
-
4, pages 14 to 15.
24 VAC AUXILIARY
The pump will accept a 24 VAC signal from a water softener or other type of control equipment that responds to
flow and will run at a set speed for as long as it receives the 24 VAC signal. The connection is not polarity
sensitive (polarity is not an issue when connecting the auxiliary wires).
Instructions for use with a water softener:
Pre
-
Programming Requirements, steps A
-
D, pages 12 to 13.
Program Pump for AUXILIARY mode (water softener), steps 1
-
4, pages 16 to 17.
Instructions for use with other equipment that responds to flow:
Pre
-
Programming Requirements, steps A
-
D, pages 12 to 13.
Program Pump for AUXILIARY mode (other equipment), steps 1
-
2 page 18.
DRY CONTACT FLOW SWITCH
The pump will accept a dry (non
-
voltage) contact from a flow switch and will run at the set speed for as long as it
receives the dry contact. The connection is not polarity sensitive (polarity is not an issue when connecting the flow
switch wires).
Instructions:
Pre
-
Programming Requirements, steps A
-
D, pages 12 to 13.
Program Pump for FLOW SWITCH mode, steps 1
-
2, page 19.
Installation, Operation and Maintenance Manual
Matrixx Oxi
-
Gen MO
-
1, MO
-
2, MO
-
3, MO
-
4, System
