USR4204 User Guide
Page
27
of
52
USR4204. See
"
Clearing A Forgotten or Disabled Administrator Name
and Password
"
for details.
See
FAQs and Troubleshooting
for suggested security guidelines.
Config Security Menu (Main Menu
Y
U)
At the top of the Configure Security Menu is the menu name. A list of valid commands, text,
and status follows. Invalid commands are ignored.
Use a Select command (see below) to set up the Administrator and up to 15 User accounts.
'0' Select Admin
Navigate to the Administrator Menu with this command. It is the only command available if
security is off. Use this command to setup the Administrator account and turn on security.
'1'–'9' and 'A'–'F' Select User
Navigate to the corresponding User Menu with this command. The current User status
(ON/OFF) is shown in parentheses next to the User name. Use this command to setup a
User account.
NOTE: To re-enable a disabled or locked out user, select the user then Toggle
the User Enable status to 'ON'.
Configure Security Menu (current enabled state in parentheses below)
CMD CMD
'0' Select "Admin Username " Admin '8' Select " " (OFF)
'1' Select " " (OFF) '9' Select " " (OFF)
'2' Select " " (OFF) 'A' Select " " (OFF)
'3' Select " " (OFF) 'B' Select " " (OFF)
'4' Select " " (OFF) 'C' Select " " (OFF)
'5' Select " " (OFF) 'D' Select " " (OFF)
'6' Select " " (OFF) 'E' Select " " (OFF)
'7' Select " " (OFF) 'F' Select "User 15 " (ON )
'-' Return to Config Parameters Menu '&' Remove ALL Accounts
