- 48 -
The LaserPoint is not powering
on when the Power Button is
placed in the on
position.(continued)
Power issues can be a result of a faulty or damaged power cord.
Try another cord on the LaserPoint or test the power cord with
another device to verify that the power cord is working properly.
If the problem is not a result of either the outlet or power cord,
there may be a connection problem inside of the machine.
With
the power switch in the off position and the power cord
removed
, remove the left side panel of the LaserPoint cutter and
check all of the connections from the power cord and power
switch. Repair or replace as necessary.
While attempting to cut, the
Blade of the LaserPoint will not
lower.
The Locking Knob of the Carriage Arm may have become over
tightened and is protruding through the back of the Carriage Arm,
blocking the arm from lowering. Loosen this until there is no
longer a blockage.
When starting the SignBlazer
Software it fails to find
updates.
This is a regular occurrence of the SignBlazer software and should
not be considered a problem. All features of the software will
continue to work in trial mode without updates.
To deactivate the update process, redirect the shortcut (
of either the
desktop icon or start menu selection that you use to open the SignBlazer
software
) to SignBlazer. Right-click it and select Properties. From
the Properties menu, change last section of the Target option from
“sb.exe” to “sbnt.exe”. Press the Apply button, then the OK
button. This will bypass the update process.
Cuts are jagged or inconsistent.
The Blade may be dulled or damaged. Replace with a new blade
and try again. Make sure that the blade can turn freely (
by
attempting to turn it with your fingers while the release button of the Blade
Carriage is pressed
).
Adjust the blade depth of the Blade Carriage(
page 17
) and Pressure
Setting on the cutter(
Page 9
) until you are getting solid, uniform
cuts. Start with a blade depth of around 1/64
th
of an inch and a
pressure setting of 120 and try an increased pressure setting before
attempting to increase the blade depth.
Other solutions may be found by visiting the Customer Forums or Technical Support Website, or by calling the
Technical Support Line (Web page addresses and Phone number on the specifications page, 46).
