Urrea LP807B, Manual

Page: 8 / 12

8
TOOL USE AND CARE
Do not force the power tool. Use the correct
tool for the application. The correct tool will do
the job better and more safely at the rate that it
was designed to work at.
Do not use tools if switch does not turn it on or
off. Any tool that cannot be controlled with the
switch is dangerous and must be repaired.
Disconnect the plug from the power source be-
fore making any adjustments, changing acces-
sories or storing the tool. This preventive safety
measures reduce the risk of accidental starting
of the tool.
When the power tool is not in use, store it out
of the reach of children, and do not allow in-
dividuals who are not familiar with the power
tool or these instructions to operate it. Power
tools are dangerous in the hands on untrained
users.
Maintain the power tool. Check for misalign-
ment or binding of moving parts, broken parts,
and any other condition that may affect the
operation of the power tool. If it is damaged,
have it repaired before using. Many accidents
are caused by poorly maintained power tools.
Check for misalignment or bonding of moving
parts, breakage parts, and any other condition
that may affect the tools operation. If you find
a damaged tool, take it to service before use it.
Use only accessories that are recommended by
the manufacturer of your model. Suitable ac-
cessories for one tool, may become hazardous
when are used on another tool.
Keep cutting tools, sharpened and clean. Cut-
ting tools in good condition with sharpened
edges, are less likely to stuck in workpieces or
easier to control.
Is recommendable to use a safety device suit-
able, such a thermal and differential switch
when you are using an electric equipment.
SERVICE
Tool service must be performed only by quali-
fied repair personnel. Service or maintenance
performed by unqualified personnel could re-
sult in a risk of injury.
SPECIFIC SAFETY RULES FOR
ANGLE POLISHER
• Use clamps, or another practical way to insure
and support the work piece to a stable base.
Holding the work piece by hand or against your
body is unstable and may cause loss of control.
• Maintain tools with care. Keep cutting tools
sharp and clean. Properly maintained tools, with
sharp cutting edges are less likely to be inter-
locked and are easier to control.
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. SPINDLE LOCK BUTTON.
2. ”D” AUXILIARY HANDLE.
3. SPEED CONTROLLER.
4. SAFETY SWITCH.
5. ON/OFF SWITCH.
6. POLISHING PLATE AND WOOLEN PAD.
TECHNICAL DATA
LP807B
VOLTAGE-FREQUENCY
120 V ~ 60 Hz
NO LOAD SPEED (900 - 3 000) r/min
PLATE CAPACITY 7" (177,8 mm)
POWER 1 300 W
POWER CONSUMPTION 1,3 kWh
WEIGHT 3 kg (6,6 lb)
ASSEMBLY INSTRUCTIONS
CAUTION: Always be sure that the tool is
switched off and unplugged before carrying
out any work on the tool.
FITTING ”D” AUXILIARY HANDLE
Always install the auxiliary handle on the tool
before operation.
Hold the tool’s switch handle and the auxiliary
handle firmly with both hands during installa-
tion. Hold in the auxiliary handle in position
and aim at hole in the gear box. Install the
bolts and tighten them with the hex wrench.
The auxiliary handle can be installed in two
different directions; whichever is convenient
for your work (left & right).
6
2
4
3
5
1