13
E N G L I S H •
User’s manual
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. TANK.
2. ON/OFF SWITCH.
3. AIR FILTER.
4. WHEELS.
5. HUMIDITY DRAIN VALVE.
ASSEMBLY & ADJUSTMENTS
HANDLE
The handle must be fitted in the following
manner:
1. Loosen the screws in each of the handle fix-
ing tubes using an hex key (not included).
2. Insert the two ends of
the handle into the fixing
tubes.
3. Tighten the screws to se-
cure the handle in place,
using an hex key wrench
(Fig.1).
WHEELS
1. To fit the wheels first insert an axle pin
through the wheel and then insert the spacer
on the underside of the wheel.
2. Fit the wheel assembly through the hole in
the bracket under the tank.
3. Fit the flat washer, split
washer and nut. Tighten
the nut from the under-
side of the wheel, and
tap on the wheel cover.
4. Repeat for the second
wheel.
RUBBER FEET
Fit the rubber feet on
the bracket on the front
underside of the tank
using the screws, wash-
ers and nuts supplied
(Fig. 3).
OIL
WARNING: The air compressor must be
filled with oil prior first use.
To prevent possible spillage of oil during trans-
port, the compressor oil is supplied in a sepa-
rate container. It must be added to the com-
pressor before turning the compressor on.
Failure to add the oil will cause non repairable
damage to the compressor and will void the
warranty.
1. Remove the plastic
oil filling cap (Fig.4) lo-
cated on the top of the
crank case of the com-
pressor housing.
2. Use the oil supplied
to fill the crank case un-
til the oil level as seen in
the oil level glass is up
to the mid point of the
red circle (Fig.5).
3. Replace the oil filling cap. Make sure the cap
is fully fitted and firmly in position.
AIR FILTER
WARNING: The air filter must be added
before first use. Failure to fit the air filter will
damage the compressor and will void the war-
ranty.
1. Remove the plastic air filter plug from the
head of the compressor.
2. To fit the air filter you need to take it apart
first. Undo the wing nut, and remove it along
with the washer from the air filter.
3. Remove the cover and the air filter.
Fig.5
Fig.4
5
3
1
2
4
Fig.3
Fig.1
COMP825-850 manual.indd 13
02/12/15 9:32 a.m.
