12
Remove the screw and wash-
er from the top of the deck,
slide the metal bracket into
the desired position (Fig.1)
and then fix in place re-using
the screw and washer.
Ensure the bracket is perpendicular to the deck
and positioned inline with the blade. Loosen-
ing this screw allows some minor adjustment
to ensure the bracket does not foul the tile
when cutting, or if the laser needs slight re-
alignment.
Put the cover (45° vertical fence) back into
position.
INSTALLATION OF THE DIAMOND DISC
Unplug the tile cutter from
the mains supply.
Remove the cover (45° verti-
cal fence) of the water tank.
Insert the inner flange, the
diamond disc and the outer
flange on the spindle (Fig.2)
then tighten the bolt clock-
wise with the two spanners
provided (Fig.3).
Insert the blade lower guard
with the chain into the
notches then tighten the 2
screws (Fig.4).
Put the metal cover back
into position.
INSTALLATION OF THE PROTECTIVE GUARD
Unplug the tile cutter from
the mains supply.
Place the guard onto the
metal bracket and fix in
place using the screw and
washer (Fig.5). Push the
cover cap over the nut.
Cover the diamond disc with the guard.
Ensure that protective guard can move freely
and that it cannot touch the disc.
Do not over tighten the protective guard when
fixing it. The guard should be free to rise and
fall as the workpiece is pushed towards the
disc.
INSTALLATION OF THE PARALLEL GUIDE
Unplug the tile cutter from
the mains supply.
Insert spring, clamp, washer
and knob to the bolt of
parallel guide (Fig.6), then
tighten the knob to fix this
part in parallel (Fig.7).
Put the parallel guide onto
the work table and fix it us-
ing the plastic securing knob
(Fig.8)
Mitre cutting can be per-
formed by using the mitre
cutting guide. The angle can
be adjusted from 0° to 45° by
unscrewing the plastic screw
(Fig.9)
- To perform 15°,30° or 45° bevel cutting, raise
one side of the table, lever out the support and
locate the tabs into the corresponding holes in
the deck (Fig.10). Ensure that the deck is cor-
rectly secured before working.
EXTENSION OF THE WORKING TABLE
Unplug the tile cutter from
the mains supply.
Pull out the table extension
to the required length and
then secure using the screw
shown in (Fig.11).
FILLING THE WATER TANK
Before cutting, the tank must be filled with
water:
· Unplug the tile cutter from the mains supply.
· Remove the metal cover from the working
table.
· Fill the tank with water in order to just cover
the disc edge (ensure that no more than ¼ of
the disc is submerged in water).
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7
Fig.8
Fig.9
Fig.11
Fig.10
CC707 manual.indd 12
28/05/15 15:44
